2/24/2008
Removal of rear bumper –
1.Remove any cable ties or cables which have
been used as a secondary fixing for the rear bumper
2.Unclip the rear exhaust springs and remove the exhaust
if the exhaust mount is secured onto the rear bumper
3.The rear bumper will be secured with either two nuts at
each side or a Allen bolt, this securing method works by compressing a piece of rubber in the
chassis rail, as you tighten the bolts or bolt the rubber expands securing the bumper
4.To remove slacken off all nuts / bolts, DO NOT remove
completely as it will be hard to remove the rubber from within the rear chassis rails, If
you do un-tighten to far once you have removed the bumper use at the end of a metal coat hanger
bent over to hook out the rubber
5.Once the mounts are loose take a careful note
of the order of any washers / alloy positions
6.Pull backwards evenly on each of either side of the
bumper pulling parallel with the chassis rails (to keep the rubber straight)
7.Once the bumper is removed spray 20/40 or WD40 into the
end of the chassis rails to add protection against rust
maccKARTING Limited will not
accept any liability for injury or accidents arising from racing, driving or
any other
use of the tips provided.
All tips / how to guides are general, certain kart
types may vary slightly from the tips provided.
Karting tips can be printed
and copied, It is forbidden to use Karting Tips documents for commercial gain
or publish
this document in any media form without the express permission of maccKARTING
Limited
