2/24/2008
Removal of Brake Carrier –
1.Remove brake side rear wheel
2.Remove brake side rear hub
3.Some axles have a collar fitted which will be butt up
against the wheel bearings, remove the two small grub screw
4.Spray the whole length of the axle with 20/40 or WD40
ensuring that you spray into the bearing to lubricate the axle, this will allow for easy removal
of the axle in the next steps
5.Locate and remove all grub screws from the wheel
bearings, you may need to remove tape or cable ties to access the screws
6.On the brake disc slacken off all the bolds securing the
disc to the carrier and slacken off the main disc carrier securing bolt
7.Ideally the next steps are best performed with two
people, one person should firmly hold the engine side of the axle pulling towards them
(outwards)
8.The other person should take a rubber mallet and tap the
end of the axle knocking it through the bearings, continue to apply further lubricant if
required to aid the removal
9.As the end of the axle approaches the brake disc carrier
be careful that the disc does not drop down onto the floor as it will shatter
10.The Brake disc is now free to remove (you do
NOT need to completely remove the axle)
maccKARTING Limited will not
accept any liability for injury or accidents arising from racing, driving or
any other
use of the tips provided.
All tips / how to guides are general, certain kart
types may vary slightly from the tips provided.
Karting tips can be printed
and copied, It is forbidden to use Karting Tips documents for commercial gain
or publish
this document in any media form without the express permission of maccKARTING
Limited
