2/24/2008
Remove the sprocket carrier –
1.Remove Sprocket side rear wheel
2.Remove the sprocket
3.Determine the size of allen key to undo the
fixing bolt usually 6mm or 8mm
4.Spray the axle and base of the sprocket
carrier with 20/40 or WD40
5.The sprocket carrier is now ready for removal
6.Slide off the carrier
7.If the carrier does not move Tape the carrier gently
running the mallet along the axle to ensure you hit the carrier square on, if you do not
have the space due to the bearing hanger then hold a small
length of timber against the
inside sprocket base taping the end of the timber with your mallet
8.Carrier will start to move, if it doesn't use a flat
wide blade screwdriver and tap between the machined break on the carrier, this will
slightly open up the internal size of the carrier, which will aid removal
9.Ensure you keep the axle key safe
maccKARTING Limited will not
accept any liability for injury or accidents arising from racing, driving or
any other
use of the tips provided.
All tips / how to guides are general, certain kart
types may vary slightly from the tips provided.
Karting tips can be printed
and copied, It is forbidden to use Karting Tips documents for commercial gain
or publish
this document in any media form without the express permission of maccKARTING
Limited
