2/24/2008
Removal of the throttle/brake pedal –
1.The pedal is usually held on using a one or
two 8mm nuts depending on type
2.Disconnect any cables or rods attached, the
brake arm sometimes has a quick release pin
3.Ensure all safety cables are also removed
from the brake pedal
4.Carefully remove the pedal return spring
5.Remove the nuts/bolts using appropriate
spanners, usually 13mm
6.The pedal can be sometimes spaced out and fitted on a
separate shaft so when sliding pedal away be careful to retain washers/spacers and the
shaft.
7.Remembering order of disassembly
NOTE - CHECK FOR ANY CRACK TO WELDS OR ANY
UNSERVICABLE DAMAGE
maccKARTING Limited will not
accept any liability for injury or accidents arising from racing, driving or
any other
use of the tips provided.
All tips / how to guides are general, certain kart
types may vary slightly from the tips provided.
Karting tips can be printed
and copied, It is forbidden to use Karting Tips documents for commercial gain
or publish
this document in any media form without the express permission of maccKARTING
Limited
