2/24/2008
Removing a track rod –
1.Locate the two bolts retaining the track rod
onto the stub axle and the steering column
2.Determine the size of spanners or allen keys your will
need (Normally 13mm spanners and 8mm allen key)
3.Remember the order at which any spacers (this
will be crucial when refitting)
4.Undo nuts and bolts at both ends of the track
rod ensuring you retain
5.Once the bolts are removed the track rod can
be removed
6. NOTE - Check for
any damage to the bearings on the end of the track rods, known as the rose joints and replace if there is any lateral
play in the bearings
NOTE - CHECK FOR ANY CRACK TO WELDS OR ANY UNSERVICABLE
DAMAGE
maccKARTING Limited will not
accept any liability for injury or accidents arising from racing, driving or
any other
use of the tips provided.
All tips / how to guides are general, certain kart
types may vary slightly from the tips provided.
Karting tips can be printed
and copied, It is forbidden to use Karting Tips documents for commercial gain
or publish
this document in any media form without the express permission of maccKARTING
Limited
