2/24/2008
Installation of a sprocket carrier
1.Remove sprocket side rear wheel and hub
2.Check for any prior damage with elongated attachment
holes, cracks and rounded of main attachment bolt,
3.Fit the appropriate steel key way and slide the sprocket
carrier over the axle to ensure the carrier lines up with key way
4. Position to desired alignment and tighten up the
main attachment bolt being careful not to over tighten
5.Align with engine sprocket by using either a
laser aligner or steel rule
NOTE - IT IS CRUCIAL THAT YOU MUST LINE UP
THE CARRIER/SPROCKET WITH THE ENGINE TO ENSURE NO DAMAGE OCCURS TO CHAIN AND SPROCKETS WHEN
ENGINE IS RUNNING.
maccKARTING Limited will not
accept any liability for injury or accidents arising from racing, driving or
any other
use of the tips provided.
All tips / how to guides are general, certain kart
types may vary slightly from the tips provided.
Karting tips can be printed
and copied, It is forbidden to use Karting Tips documents for commercial gain
or publish
this document in any media form without the express permission of maccKARTING
Limited
