2/24/2008
2/24/2008
Installation of the sprocket & Chain
1. Prior
to fitment, check sprocket and carrier attachment holes for elongation, if so
replace,
2.Remove Sprocket side rear wheel
3.Remove Chain guard
4.Loosen
engine clamp bolts and for engine back
5.Position sprocket and fit all bolts previously removed
and ensure the Nyloc nuts are still in good condition
6. Tighten all nuts and bolts using
appropriate spanners
7.Fit chain
8.Push engine forward until chain is set with
correct tension (1cm movement up and down)
9.Tighten engine clamp bolts
10.Align with engine sprocket by using either a
laser aligner or steel rule
11.Recheck chain tension
12.Replace rear wheel
NOTE - ROTATE THE AXLE AT SPPED AND CHECK FOR ANY
DISTORTION IN THE SPROCKET AND CARRIER.
maccKARTING Limited will not
accept any liability for injury or accidents arising from racing, driving or
any other
use of the tips provided.
All tips / how to guides are general, certain kart
types may vary slightly from the tips provided.
Karting tips can be printed
and copied, It is forbidden to use Karting Tips documents for commercial gain
or publish
this document in any media form without the express permission of maccKARTING
Limited
