2/24/2008
Installation of a track rod
1.Prior to fitment ensure that there are no
cracks bends or damage bearings in the rose joints
2.Locate all previously removed bolts and spacers and
remembering the sequence of removal position bolts and spacer stack onto steering column and
stub axle.
3. Push through the bolt completely and
nut up and tighten using appropriate spanners.
4. This now ready for set up known as
tracking
NOTE - WHILE TIGHTENING BOLTS ENSURE THAT THE
ROSE JOINT IS KEPT PARRALEL TO its FIXING BRACKET THIS WILL ENSURE THAT YOU MAINTAIN
FULL AND FREE MOVEMENT OF THE BEARING REDUCING ANY RISK OF STIFF MOVEMENT AND POTENTIAL
WEAR.
maccKARTING Limited will not
accept any liability for injury or accidents arising from racing, driving or
any other
use of the tips provided.
All tips / how to guides are general, certain kart
types may vary slightly from the tips provided.
Karting tips can be printed
and copied, It is forbidden to use Karting Tips documents for commercial gain
or publish
this document in any media form without the express permission of maccKARTING
Limited
